OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0883

TCM Power Input Signal High

The TCM power input codes watch the supply voltage of the gearbox module or of its solenoid supply. Without a proper supply all solenoids go dead and the gearbox falls back to its hydraulic emergency gear with maximum line pressure: a fixed gear, harsh engagement, no shifting. Ford's external gearbox modules check a window of 9 to 16 V; GM reports the same under P0562/P0563. P0883 means the supply is too high: Ford sets it above 16 V, continuously and with MIL; GM's counterpart P0563 sets at 18 V. Typical triggers are a failed alternator regulator or a jump start with 24 V. Overvoltage endangers the output stages, so the module may switch the solenoids off.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 83

Possible causes

  • Alternator voltage regulator faulty (overcharging) high
  • Jump start with 24 V or charger in boost mode medium
  • Poor battery ground, regulator measures wrongly medium
  • Module measurement faulty low

Symptoms

  • MIL on
  • Charging warning or unusually bright lights
  • Overvoltage codes in other modules

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0883

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication