OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0882

TCM Power Input Signal Low

The TCM power input codes watch the supply voltage of the gearbox module or of its solenoid supply. Without a proper supply all solenoids go dead and the gearbox falls back to its hydraulic emergency gear with maximum line pressure: a fixed gear, harsh engagement, no shifting. Ford's external gearbox modules check a window of 9 to 16 V; GM reports the same under P0562/P0563. P0882 means the supply is too low: Ford sets it below 9 V, continuously and with MIL. Chrysler's RFE, RLE and TE automatics test it when the key goes to run: if the module reads less than 3 V at the transmission control relay outputs while commanding the relay on, the code sets and the solenoids stay dead.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 82

Possible causes

  • Weak battery or alternator not charging high
  • Transmission relay, fuse or fuse box module faulty (Chrysler) high
  • Corroded ground or supply wire, connector at the module medium
  • Module faulty low

Symptoms

  • MIL on
  • Limp mode in a fixed gear, no shifting
  • Torque converter clutch stays open

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0882

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication