P0880
TCM Power Input Signal
The TCM power input codes watch the supply voltage of the gearbox module or of its solenoid supply. Without a proper supply all solenoids go dead and the gearbox falls back to its hydraulic emergency gear with maximum line pressure: a fixed gear, harsh engagement, no shifting. Ford's external gearbox modules check a window of 9 to 16 V; GM reports the same under P0562/P0563. P0880 is the general fault. Hyundai's 2017–19 six-speed automatics set it when the solenoid supply drops below 7 V or rises above 22 V: MIL on, limp mode in 4th gear. Hyundai's bulletin points to the valve body harness and the TCU fuses and expressly not to the gearbox.
Possible causes
- Harness or connector between module and valve body damaged or corroded high
- TCU fuse or transmission relay faulty medium
- Weak battery, charging fault, poor ground medium
- Gearbox module faulty low
Symptoms
- MIL on
- Limp mode in a fixed gear, no shifting
- Harsh engagement into D or R
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0880
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.