P0876
Transmission Fluid Pressure Sensor/Switch D Circuit Range/Performance
Transmission fluid pressure switches C and D report whether a clutch circuit is pressurised. They are more widespread than A and B: GM's 6L80/6L90 and 6T40/6T70 six-speeds put switch C on the 2-6 brake and D on the 1-2-3-4 clutch, Allison uses them for its third shift valve and its reverse switch, Ram's RFE gearboxes for the clutch pressure switches in the solenoid block. Ford reports pressure faults under its solenoid codes. P0876 means D is electrically fine but implausible. Allison 2006: the reverse switch stays open in R, or does not drop out within 5 to 30 s after engine stop, type B with two trips. Mitsubishi's Jatco CVT sets it when the high clutch switch stays on for 1.5 s while the clutch should be exhausted. On Ram's 68RFE it came with P0871 from mechanical damage.
Possible causes
- Valve body worn or dirty, valve sticking high
- Pressure switch faulty medium
- Mechanical damage: thrust washer, clutch medium
- Fluid level or condition low
Symptoms
- MIL or transmission warning lamp on
- Limp mode, harsh engagement
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0876
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.