P0874
Transmission Fluid Pressure Sensor/Switch C Circuit Intermittent
Transmission fluid pressure switches C and D report whether a clutch circuit is pressurised. They are more widespread than A and B: GM's 6L80/6L90 and 6T40/6T70 six-speeds put switch C on the 2-6 brake and D on the 1-2-3-4 clutch, Allison uses them for its third shift valve and its reverse switch, Ram's RFE gearboxes for the clutch pressure switches in the solenoid block. Ford reports pressure faults under its solenoid codes. P0874 reports short dropouts or flutter of the C signal without a lasting low or high. It is documented only in GM bulletin 21-NA-033 for the Corvette C8 dual clutch, with MIL: dirt and sticking valves are cleaned, the clutches relearned, and only then the circuit traced. Thresholds are not published.
Possible causes
- Loose contact or corrosion at connector or harness high
- Dirt or sticking valve (dual clutch) medium
- Sensor or switch with dropouts medium
- Low fluid level, pressure drops in corners low
Symptoms
- Warning lamp coming and going
- Occasional harsh shift or limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0874
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.