OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0873

Transmission Fluid Pressure Sensor/Switch C Circuit High

Transmission fluid pressure switches C and D report whether a clutch circuit is pressurised. They are more widespread than A and B: GM's 6L80/6L90 and 6T40/6T70 six-speeds put switch C on the 2-6 brake and D on the 1-2-3-4 clutch, Allison uses them for its third shift valve and its reverse switch, Ram's RFE gearboxes for the clutch pressure switches in the solenoid block. Ford reports pressure faults under its solenoid codes. P0873 means switch C reports no pressure although its clutch should be applied. GM checks it when the 2-6 brake is commanded above 700 kPa and sets it after 15 counts on the 6L80 or 20 on the 2010 6T70, without MIL. Allison sets it after 0.125 s (2006) or 0.175 s (2007) without pressure at an applied valve, then tells electrical from mechanical by the companion solenoid code, type A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 73

Possible causes

  • Signal wire or connector open (gearbox pass-through, harness) high
  • Pressure switch does not close (diaphragm, seal) medium
  • Clutch pressure does not build: low fluid, leak, regulator valve medium
  • Gearbox module input low

Symptoms

  • Code stored in the gearbox module; on GM without MIL, on Allison with MIL
  • Shift shock or slip in gears using clutch C

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0873

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication