OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0872

Transmission Fluid Pressure Sensor/Switch C Circuit Low

Transmission fluid pressure switches C and D report whether a clutch circuit is pressurised. They are more widespread than A and B: GM's 6L80/6L90 and 6T40/6T70 six-speeds put switch C on the 2-6 brake and D on the 1-2-3-4 clutch, Allison uses them for its third shift valve and its reverse switch, Ram's RFE gearboxes for the clutch pressure switches in the solenoid block. Ford reports pressure faults under its solenoid codes. P0872 means switch C reports pressure while its clutch is exhausted. GM checks it only when the 2-6 brake is commanded below 50 kPa, after a temperature-dependent delay, and counts one fault per clutch change: 10 on the 6L80, 18 on the 2010 6T70; listed as 'special no trip', without MIL. Allison 2007 sets it when switch 3 reports pressure for over 20 ms with the valve at rest, type A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 72

Possible causes

  • Pressure switch stuck closed or shorted internally high
  • Signal wire shorted to ground inside the gearbox medium
  • Clutch circuit does not exhaust: dirt, sticking valve medium
  • Gearbox module low

Symptoms

  • Code stored in the gearbox module; on GM without MIL, on Allison with MIL
  • Harsh shifts, possibly substitute gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0872

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication