P0870
Transmission Fluid Pressure Sensor/Switch C Circuit
Transmission fluid pressure switches C and D report whether a clutch circuit is pressurised. They are more widespread than A and B: GM's 6L80/6L90 and 6T40/6T70 six-speeds put switch C on the 2-6 brake and D on the 1-2-3-4 clutch, Allison uses them for its third shift valve and its reverse switch, Ram's RFE gearboxes for the clutch pressure switches in the solenoid block. Ford reports pressure faults under its solenoid codes. P0870 is the general fault. Allison's 2006 table uses it for the switch on valve S3: if it reports pressure for more than 20 ms with the valve at rest, the valve is retried twice and the case classed as electrical, mechanical or sporadic, type A. Ram corrected false P0870 'hydraulic pressure tests' on the 2019 68RFE with a software update.
Possible causes
- Pressure switch C faulty (sticking, seal leaking) high
- Sticking shift valve or worn valve body bore medium
- Wiring or connector at the gearbox medium
- Control module software (Ram 68RFE) low
- Low fluid level low
Symptoms
- MIL or transmission warning lamp on
- Limp mode with a fixed gear
- Harsh or missing shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0870
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.