OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P086F

Neutral Position Sensor A Not Learned

Neutral position sensor A is a three-wire Hall sensor on the shift shaft of a manual gearbox that reports neutral to the engine module; start-stop may only switch the engine off in neutral. Audi uses it as sender G701 on the Q3 and A3, GM on the 2019 Corvette ZR1 manual, where its faults suspend the gear ratio checks. Thresholds and MIL status are not published. Analog neutral sensors need a learned neutral window to cover part and fitting tolerances. P086F means no valid value is stored, typically after a sensor, gearbox, clutch or module replacement, a software update or an aborted learn run; Schaeffler's patent rejects runs with an unsteady lever. FCA describes cruise control failing after service until the neutral learn is done, without new parts.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 6F

Possible causes

  • Learn procedure not done after replacing sensor, gearbox or module high
  • Learn run aborted: lever strained, linkage misadjusted medium
  • Software update deleted learned values medium
  • Sensor fitted outside the learnable range or faulty low

Symptoms

  • Start-stop not working
  • Cruise control cannot be set (FCA)
  • Fault appears after a workshop visit

Inspection / repair

  • Difficulty: easy
  • DIY: shop recommended

What Pro shows you for P086F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication