P086E
Neutral Position Sensor A Circuit Intermittent/Erratic
Neutral position sensor A is a three-wire Hall sensor on the shift shaft of a manual gearbox that reports neutral to the engine module; start-stop may only switch the engine off in neutral. Audi uses it as sender G701 on the Q3 and A3, GM on the 2019 Corvette ZR1 manual, where its faults suspend the gear ratio checks. Thresholds and MIL status are not published. P086E means the signal jumps out of range for short moments or changes implausibly fast, typically a loose contact or a chafed wire that moves with the shift shaft. Audi often stores it together with P086D when the too-short G701 wiring only breaks contact now and then.
Possible causes
- Wire at the neutral sender strained or cracked (Audi G701) high
- Loose contact or corrosion in the connector medium
- Sensor or magnet target loose low
Symptoms
- Start-stop works only at times
- Start system warning comes and goes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P086E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.