P086D
Neutral Position Sensor A Circuit High
Neutral position sensor A is a three-wire Hall sensor on the shift shaft of a manual gearbox that reports neutral to the engine module; start-stop may only switch the engine off in neutral. Audi uses it as sender G701 on the Q3 and A3, GM on the 2019 Corvette ZR1 manual, where its faults suspend the gear ratio checks. Thresholds and MIL status are not published. P086D means the signal is above its upper limit: an open signal or ground wire or a short to voltage. Audi's bulletin for the 2019–20 Q3 and 2022–23 A3 found the wires to G701 laid too short, so shifting pulled them apart; all three are lengthened by 20 mm. The cluster shows a start system fault.
Possible causes
- Wire to the neutral sender broken or laid too short (Audi G701) high
- Connector loose or corroded medium
- Sensor open internally medium
- Ground wire open low
Symptoms
- Start system fault message (Audi)
- Start-stop not working
- Fault appears after gear changes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P086D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.