OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P086C

Neutral Position Sensor A Circuit Low

Neutral position sensor A is a three-wire Hall sensor on the shift shaft of a manual gearbox that reports neutral to the engine module; start-stop may only switch the engine off in neutral. Audi uses it as sender G701 on the Q3 and A3, GM on the 2019 Corvette ZR1 manual, where its faults suspend the gear ratio checks. Thresholds and MIL status are not published. P086C means the signal is below its lower limit: signal wire shorted to ground, supply missing or a sensor without output. GM lists it among the exclusions of its gear checks; the neutral state is then unknown and start-stop stays off.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 6C

Possible causes

  • Signal wire shorted to ground or supply wire open or chafed high
  • Neutral position sensor faulty medium
  • Corrosion or water in the connector medium
  • 5 V reference of the module disturbed low

Symptoms

  • Start-stop not working
  • Start system warning in the cluster (Audi)
  • No noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P086C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication