P086B
Neutral Position Sensor A Range/Performance
Neutral position sensor A is a position sensor, usually a three-wire Hall sensor, on the shift shaft of a manual gearbox. It tells the engine module that neutral is selected, which start-stop needs before it may switch the engine off. Analog versions need a learned neutral value (P086F). Audi uses it as sender G701 on Q3 and A3, GM on the 2019 Corvette ZR1 with its 7-speed manual, where these codes suspend the gear ratio checks. P086B means the signal is valid but implausible: it reports neutral although engine and road speed show a gear, never shows neutral, or lies outside the learned window. Patents describe learning neutral and rejecting unsteady runs.
Possible causes
- Sensor or magnet target loose, misaligned or covered with metal debris high
- Learned value missing or wrong after gearbox, clutch or sensor work medium
- Sensor drifting medium
- Contact resistance in the connector low
Symptoms
- Start-stop not working or behaving oddly
- Warning about start-stop or start system
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P086B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.