P086A
Neutral Position Sensor A Circuit/Open
Neutral position sensor A is a position sensor, usually a three-wire Hall sensor, on the shift shaft of a manual gearbox. It tells the engine module that neutral is selected, which start-stop needs before it may switch the engine off. Analog versions need a learned neutral value (P086F). Audi uses it as sender G701 on Q3 and A3, GM on the 2019 Corvette ZR1 with its 7-speed manual, where these codes suspend the gear ratio checks. P086A is the circuit fault: the signal is missing, typically an open supply or signal wire. Audi's bulletin for the sister codes P086D/P086E found the supply wires to G701 too short and lengthened them. Start-stop stays off.
Possible causes
- Wire or connector to the sensor open or chafed high
- Sensor faulty medium
- Corroded connector low on the gearbox medium
- Supply output of the control module low
Symptoms
- Start-stop not working
- Warning about the start system
- MIL possible depending on maker
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P086A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.