OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0868

Transmission Fluid Pressure Low

P0867 to P0869 cover the system or line pressure of the gearbox as a whole: a pressure sensor measures it and the control module compares it with the pressure it commands. Faults of the sensor circuit itself have their own codes (Chrysler 68RFE P0932 ff), the single switches A to H have theirs (P0840 ff). Thresholds are not published; the codes are documented in bulletins for the Ram 68RFE and for the Tremec dual clutch of Corvette C8 and Maserati MC20. P0868 means the measured pressure stays below target. Chrysler calls it 'Line Pressure Low' on the 68RFE and fixed some cases with a software update; on 2024 Ram trucks it came with P0841 from a failed rear thrust washer. On the Corvette a sticking pressure valve is typical. The module then commands maximum pressure.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 68

Possible causes

  • Fluid level low, leak or clogged filter high
  • Pressure control valve or solenoid sticking from dirt high
  • Internal leakage or mechanical damage: thrust washer, seal rings, pump medium
  • Software calibration of the target pressure low
  • Line pressure sensor reading low low

Symptoms

  • Transmission warning lamp or MIL on
  • Slipping, delayed engagement
  • Limp mode
  • Overheating under load

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0868

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 5 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication