OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0866

TCM Communication Circuit High

The TCM communication circuit is a direct link between gearbox and engine module outside the CAN bus. Subaru's 2005 WRX, sold as Saab 9-2X, uses a single 'AT diagnosis' wire: about once a second the gearbox module sends a frame with a start pulse of 40 ms low and 20 ms high, carrying among other things its request for the MIL. On CAN cars, loss of the gearbox module sets U0101 or U0402 instead. P0866 means the line stays high for more than 3 s with no start pulse, MIL after two trips. Over 10 V at the engine module pin points to a short to voltage; a voltage switching between 1 and 4 V is a healthy signal. A gearbox module without power sends nothing, so the pull-up keeps the line high and the gearbox runs in a fixed gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 66

Possible causes

  • Gearbox module without power or ground, or faulty high
  • Line between the modules open medium
  • Line shorted to voltage medium
  • Poor contact at a module connector medium

Symptoms

  • Check engine lamp after two trips
  • Gearbox in limp mode with fixed gear if its module has no power
  • Gearbox faults not passed to the engine module

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0866

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication