P0865
TCM Communication Circuit Low
The TCM communication circuit is a direct link between gearbox and engine module outside the CAN bus. Subaru's 2005 WRX, sold as Saab 9-2X, uses a single 'AT diagnosis' wire: about once a second the gearbox module sends a frame with a start pulse of 40 ms low and 20 ms high, carrying among other things its request for the MIL. On CAN cars, loss of the gearbox module sets U0101 or U0402 instead. P0865 means the line stays low for more than 3 s, MIL after two trips. The engine module pulls the line up; the procedure measures below 1 V at the engine module pin with ignition on, checks the harness for a short to ground and then reads the gearbox codes or replaces the gearbox module.
Possible causes
- Line between the modules shorted to ground high
- Gearbox module faulty, holding the line low medium
- Poor contact at engine or gearbox module connector medium
- Pull-up in the engine module faulty low
Symptoms
- Check engine lamp after two trips
- Gearbox faults not passed to the engine module
- Shift problems possible
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0865
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-2x-9346/2005/0-general/general-diagnostics-2-0t/diagnostic-trouble-code-dtc-detecting-criteria/fault-diagnosis-fault-codes/dtc-p0865-tcm-communication-circuit-low
- saabwisonline.com/9-2x-9346/2005/2-engine/engine-diagnostics-2-0t/diagnostic-procedure-with-diagnostic-trouble-code-dtc/fault-diagnosis-fault-codes/dtc-p0865-tcm-communication-circuit-low
- law.cornell.edu/regulations/california/13-CCR-1968.2