OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0864

TCM Communication Circuit Range/Performance

The TCM communication circuit is a direct link between gearbox and engine module outside the CAN bus. Subaru's 2005 WRX, sold as Saab 9-2X, uses a single 'AT diagnosis' wire: about once a second the gearbox module sends a frame with a start pulse of 40 ms low and 20 ms high, carrying among other things its request for the MIL. On CAN cars, loss of the gearbox module sets U0101 or U0402 instead. P0864 means signals arrive but in the wrong format: Subaru sets it after 60 s without a valid frame while driving above 500 rpm and 10.9 V, MIL after two trips. The service procedure checks shifting, then interference from aftermarket radios with bad grounds, then replaces the gearbox module. GM's 2005 2.8 and 3.6 V6 report it with U0101 when gearbox messages are missing for 2.5 s.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 64

Possible causes

  • Gearbox module faulty or its software high
  • Interference from retrofitted radio or phone with poor ground medium
  • Loose contact in wire or connector between the modules medium
  • Low supply voltage low

Symptoms

  • Check engine lamp after two trips
  • Shift problems or limp mode possible
  • Often no noticeable effect

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0864

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication