P0859
Traction Control Input Signal High
The traction control input carries the request of the ABS/stability module to the engine module to cut torque when wheels spin. Older cars used a wire with a voltage or duty-cycle signal, hence the low and high variants; today it is a CAN message, where pure loss of communication sets U0121 or U0415 instead. California's OBD rule counts traction control as a safety-only system that may be exempted, so these codes normally carry no MIL. P0859 means a wired signal stays above its upper limit: short to battery or 5 V, or an open line with a pull-up in the receiver. No maker documents the code; the request is discarded and traction control switched off.
Possible causes
- Signal wire shorted to voltage high
- Open circuit with pull-up in the engine module medium
- Ground fault of the brake module medium
- Module faulty low
Symptoms
- Traction or stability control lamp on, system switched off
- No torque reduction when wheels spin
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0859
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.