OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0857

Traction Control Input Signal Range/Performance

The traction control input carries the request of the ABS/stability module to the engine module to cut torque when wheels spin. Older cars used a wire with a voltage or duty-cycle signal, hence the low and high variants; today it is a CAN message, where pure loss of communication sets U0121 or U0415 instead. California's OBD rule counts traction control as a safety-only system that may be exempted, so these codes normally carry no MIL. P0857 means the signal is electrically valid but does not fit the driving state, such as a request without wheel slip or switching too often. No maker documents the code; GM covers such checks under P0856. The receiving module ignores the request and traction control is disabled.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 57

Possible causes

  • Software or calibration of brake or engine module medium
  • Loose contact or corrosion between brake module and engine module medium
  • Wheel speed fault in the ABS causing false slip detection medium
  • Brake module faulty low

Symptoms

  • Traction or stability control lamp on, system switched off
  • Traction control intervenes unexpectedly or not at all
  • Engine power briefly reduced

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0857

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication