P0856
Traction Control Input Signal
The traction control input carries the request of the ABS/stability module to the engine module to cut torque when wheels spin. Older cars used a wire with a voltage or duty-cycle signal, hence the low and high variants; today it is a CAN message, where pure loss of communication sets U0121 or U0415 instead. California's OBD rule counts traction control as a safety-only system that may be exempted, so these codes normally carry no MIL. GM checks the CAN torque request from the brake module: a wrong protection value or rolling count in 6 of 10 messages, or three changes of request type within 200 ms, set it, type C without MIL. On the Saab 9-4X the brake module then switches traction and stability control off for the key cycle and stores C0242.
Possible causes
- Fault in the engine module that prevents torque reduction, often with other engine codes high
- Software of engine or brake module, module faulty medium
- CAN fault, connector or ground at the brake or engine module medium
- Low supply voltage low
Symptoms
- Traction or stability control lamp on, system switched off
- No torque reduction when wheels spin
- Usually no check engine lamp
- C0242 or similar in the brake module
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0856
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2025/25OBDG03A.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2014/14OBDG10 Engine Diagnostics.pdf
- saabwisonline.com/9-4x/2011/5-brakes/tcs-esp/fault-diagnosis-diagnostic-trouble-codes/dtc-c0242-or-p0856
- law.cornell.edu/regulations/california/13-CCR-1968.2