OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0852

Park/Neutral Switch Input Circuit High

The park/neutral input tells the engine control module whether the automatic is in P or N, or a manual gearbox in neutral. It releases the starter, prepares idle control for the load of an engaged gear and enables cruise control and other monitors. All documented makers check it for plausibility against driving state or a second source such as the gearbox module. On GM's 6T70 and Subaru the switch pulls the line to ground in P/N. P0852 means the input wrongly reports a gear although P/N is selected: open wire, short to voltage or a switch that no longer closes. Subaru's manual sets it when neutral is never seen while the car changes three times between idle and 64 km/h, MIL after two trips. GM's LML Duramax sets it when the gearbox module reports P/N but the input does not, type B; the 6T70 after 0.2 s, type C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 52

Possible causes

  • Signal or ground wire or connector open high
  • P/N or neutral switch does not close high
  • Selector cable or inhibitor misadjusted medium
  • Signal wire shorted to voltage low

Symptoms

  • Engine does not crank in P/N (automatic)
  • High or rough idle
  • Cruise control blocked

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0852

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication