P084D
Transmission Fluid Pressure Sensor/Switch H Circuit High
Transmission fluid pressure sensor/switch H is the last of up to eight pressure inputs (A to H) in SAE J2012; the letter is the maker's choice. Documented uses are rare: Mitsubishi sets P084A on its Jatco CVT8 (F1CJC/W1CJC) and Ford P084B on the 2020–23 Explorer 3.3 full hybrid. For P084D no maker is documented. It means the signal is too high: a switch open although pressure should be present, a sensor above its upper limit through a short to voltage or an open ground, judged like A and B.
Possible causes
- Signal or ground wire open, connector fault high
- Sensor faulty or switch stuck open high
- Short to 5 V or battery voltage medium
- Too little pressure, switch does not close medium
- Control module low
Symptoms
- Check engine or transmission warning lamp on
- Limp mode with substitute gear or limited ratio
- Harsh or delayed shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P084D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.