P084B
Transmission Fluid Pressure Sensor/Switch H Circuit Range/Performance
Transmission fluid pressure sensor/switch H is the last of up to eight pressure inputs (A to H) in SAE J2012; the letter is the maker's choice. Documented uses are rare: Mitsubishi sets P084A on its Jatco CVT8 (F1CJC/W1CJC) and Ford P084B on the 2020–23 Explorer 3.3 full hybrid. P084B means the signal is valid but implausible. Ford bulletin 24-2019 covers the Explorer hybrid with its 10-speed: the code sets with the MIL or wrench lamp because software thresholds were too tight, and a PCM reflash fixes it, after which the shift adaptation relearns. Which measuring point Ford calls H is not stated. Otherwise the usual causes apply: sticking valve, drifting sensor, low fluid.
Possible causes
- Control module software with too tight thresholds high
- Dirty or worn valve body, sticking valve high
- Pressure sensor or switch drifting high
- Fluid level low or fluid aged medium
Symptoms
- MIL or wrench lamp on
- Shift quality changes until the adaptation has relearned
- Limp mode with substitute gear or limited ratio
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P084B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.