P084A
Transmission Fluid Pressure Sensor/Switch H Circuit
Transmission fluid pressure sensor/switch H is the last of up to eight pressure inputs (A to H) in SAE J2012; the letter is the maker's choice. Documented uses are rare: Mitsubishi sets P084A on its Jatco CVT8 (F1CJC/W1CJC) and Ford P084B on the 2020–23 Explorer 3.3 full hybrid. Mitsubishi uses P084A as a function check of the primary pulley pressure sensor: the module compares primary with secondary pressure and sets the code after 5 s outside the map at a steady ratio of 0.5 to 1.0. Electrical faults of both sensors come first as P0842/P0843/P0847/P0848; belt slip and wear debris in the fluid often follow, cured with a valve body or belt and pulley set.
Possible causes
- Valve body with faulty primary or secondary pressure sensor high
- CVT belt or pulleys damaged, slip and debris in the fluid high
- Harness or connector medium
- Control module software or module low
Symptoms
- Warning lamp on
- Judder or slipping when pulling away
- CVT limp mode with limited ratio
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P084A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 5 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.