P0848
Transmission Fluid Pressure Sensor/Switch B Circuit High
Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0848 means the B signal is too high. Allison sets it when switch 2 shows no pressure for over 0.175 s although valve S2 is applied, type A; GM's CVT when the second pulley sensor rises above 95 % duty cycle, a short to voltage or an open circuit. Mitsubishi treats it as a circuit fault to rule out first on its CVTs.
Possible causes
- Signal or ground wire open, connector soaked with fluid high
- Switch stuck open or sensor faulty high
- Signal wire shorted to 5 V or battery voltage medium
- Too little pressure at the switch: low fluid level or sticking valve medium
- Control module faulty low
Symptoms
- Check engine or transmission warning lamp on
- Limp mode with a fixed gear, harsh or missing shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0848
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.