OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0847

Transmission Fluid Pressure Sensor/Switch B Circuit Low

Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0847 means the B signal is too low. Allison sets it when switch 2 reports pressure for over 0.04 s although valve S2 is at rest, type A; GM's CVT when the second pulley sensor falls below 3 % duty cycle for 0.3 s within 0.5 s, type A. Mitsubishi's bulletin for the F1CJC CVT asks for this circuit check before belt or pulleys are blamed.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 47

Possible causes

  • Signal wire shorted to ground or, on GM duty-cycle sensors, open high
  • Switch stuck closed or sensor faulty internally high
  • 5 V supply of the sensor missing medium
  • Shift valve stuck in the applied position, so the switch reports pressure correctly medium
  • Input of the control module faulty low

Symptoms

  • Check engine or transmission warning lamp on
  • Limp mode with a fixed gear, harsh or missing shifts
  • CVT: ratio and power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0847

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication