OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0846

Transmission Fluid Pressure Sensor/Switch B Circuit Range/Performance

Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0846 is the plausibility fault of B. GM's CVT uses the same test as for A on its second pulley: pressure off target by 500 or 1500 kPa plus a ratio error above 0.2 for about 6 s, line pressure above 600 kPa, over 35 km/h, type A. Allison sets it when switch 2 stays without pressure 5 s after valve S2 is applied. On the Corvette dual clutch a sticking valve is the usual cause.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 46

Possible causes

  • Dirty or sticking valve, worn valve body high
  • Pressure sensor or switch drifting or sticking high
  • Fluid level low, fluid aged or filter clogged medium
  • Mechanical damage: thrust washer, CVT belt or pulley, pump medium
  • Control module software low

Symptoms

  • Check engine or transmission warning lamp on
  • Slipping or shift shock
  • CVT: ratio and power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0846

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication