P0845
Transmission Fluid Pressure Sensor/Switch B Circuit
Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0845 is the general circuit fault of switch or sensor B. In GM's 2006 Allison table it belongs to the switch on shift valve S2: if the switch reports pressure for more than 0.04 s with the valve at rest, the valve is commanded again; if the fault persists, the case is classed as electrical (with P0768), mechanical or sporadic. Type A, MIL after one trip.
Possible causes
- Pressure switch or sensor B faulty or stuck high
- Sticking shift valve or dirt in the valve body medium
- Harness or connector at the gearbox: fluid wicking, corrosion, chafing medium
- Fluid level low or fluid contaminated medium
- Transmission control module faulty low
Symptoms
- Check engine or transmission warning lamp on
- Limp mode with a fixed gear, harsh or missing shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0845
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.