OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0843

Transmission Fluid Pressure Sensor/Switch A Circuit High

Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0843 means the signal is too high. For a switch that is 'open although pressure should be there': Allison sets it when switch 1 stays without pressure for over 0.07 s with valve S1 applied, type A; a 2006 GM four-speed used switch A for the converter clutch release and set it after 6 s, type B. For a sensor it is a short to voltage or open: GM's CVT above 95 %, its 8-speed above 91 % duty cycle.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 43

Possible causes

  • Signal or ground wire open, connector soaked with fluid high
  • Switch stuck open or sensor faulty high
  • Signal wire shorted to 5 V or battery voltage medium
  • Too little pressure at the switch: low fluid level or sticking valve medium
  • Control module faulty low

Symptoms

  • Check engine or transmission warning lamp on
  • Limp mode with a fixed gear, harsh or missing shifts
  • Torque converter clutch stays open, higher fuel use

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0843

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication