OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0841

Transmission Fluid Pressure Sensor/Switch A Circuit Range/Performance

Transmission fluid pressure sensor/switch A and B are inputs inside the automatic gearbox. A switch only reports pressure present or absent, a sensor reports a value. The letter is the maker's choice: Allison 1000 uses A and B for the switches on shift valves S1 and S2, GM's CVT for the primary and secondary pulley sensors, GM's 2025 8-speed A for the lube pressure sensor; Ford reports pressure faults under its solenoid codes instead. P0841 means the signal is electrically fine but does not match the commanded state. GM's CVT sets it when pulley pressure misses its target by more than 500 kPa steady or 1500 kPa transient while the ratio is off by over 0.2 for about 6 s, type A. GM's 8-speed checks the lube sensor rises above 40 kPa after start-up; Mitsubishi's CVT sets it at 0.675 MPa deviation for 5 s.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 41

Possible causes

  • Dirty or sticking valve, worn valve body high
  • Pressure sensor or switch drifting or sticking high
  • Fluid level low, fluid aged or filter clogged medium
  • Mechanical damage: thrust washer, CVT belt or pulley, pump medium
  • Control module software low

Symptoms

  • Check engine or transmission warning lamp on
  • Shift shock, slipping or delayed engagement
  • CVT: ratio and power limited

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0841

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication