OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P083D

Transmission Fluid Pressure Sensor/Switch G Circuit High

Transmission fluid pressure sensor/switch G is one of up to eight pressure inputs (A to H) that SAE J2012 provides for automatic gearboxes. No maker could be found that uses the letter G: GM's tables up to 2025, Ford's summaries and Allison stop at A to E. The description therefore follows the general rule for gearbox inputs in California's OBD regulation, which demands circuit and plausibility checks, and the logic of the A and B codes. P083D means the signal is too high: a switch stays open although pressure should be present, a sensor exceeds its upper limit through a short to voltage or an open ground.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 3D

Possible causes

  • Signal or ground wire open, connector fault high
  • Sensor faulty or switch stuck open high
  • Short to 5 V or battery voltage medium
  • Too little pressure, switch does not close medium
  • Control module low

Symptoms

  • Check engine or transmission warning lamp on
  • Limp mode with substitute gear or limited ratio
  • Harsh or delayed shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P083D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication