OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P083C

Transmission Fluid Pressure Sensor/Switch G Circuit Low

Transmission fluid pressure sensor/switch G is one of up to eight pressure inputs (A to H) that SAE J2012 provides for automatic gearboxes. No maker could be found that uses the letter G: GM's tables up to 2025, Ford's summaries and Allison stop at A to E. The description therefore follows the general rule for gearbox inputs in California's OBD regulation, which demands circuit and plausibility checks, and the logic of the A and B codes. P083C means the signal is too low: a switch is closed although no pressure is expected, a sensor is below its lower limit through a short to ground or a missing 5 V supply.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 3C

Possible causes

  • Signal wire shorted to ground, or open on duty-cycle sensors high
  • Sensor faulty or switch stuck closed high
  • 5 V supply missing medium
  • Valve stuck applied, so the switch reports pressure correctly medium
  • Control module low

Symptoms

  • Check engine or transmission warning lamp on
  • Limp mode with substitute gear or limited ratio
  • Harsh or delayed shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P083C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication