P083A
Transmission Fluid Pressure Sensor/Switch G Circuit
Transmission fluid pressure sensor/switch G is one of up to eight pressure inputs (A to H) that SAE J2012 provides for automatic gearboxes. No maker could be found that uses the letter G: GM's tables up to 2025, Ford's summaries and Allison stop at A to E. The description therefore follows the general rule for gearbox inputs in California's OBD regulation, which demands circuit and plausibility checks, and the logic of the A and B codes. P083A is the general circuit fault, set when the module sees a fault on this input without telling low, high or plausibility apart.
Possible causes
- Pressure switch or sensor in the valve body faulty or stuck high
- Harness or connector at the gearbox: fluid wicking, corrosion medium
- Sticking valve in the valve body medium
- Fluid level or condition medium
- Transmission control module low
Symptoms
- Check engine or transmission warning lamp on
- Limp mode with substitute gear or limited ratio
- Harsh or delayed shifts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P083A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.