OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0839

Four Wheel Drive (4WD) Switch Circuit High

The four-wheel-drive switch tells the engine module which transfer case range is engaged. 4WD low changes the ratio of engine to road speed by about 2.7:1 on GM trucks, so GM uses 'not in 4WD low' as an enable condition for idle speed and clutch pedal checks; that is why CARB requires monitoring such inputs. P0839 means the switch signal is above its valid range – a short to positive or, with a pull-up circuit, an open in wire, switch or ground. GM describes the open for its 4WD low switch as 'continuous open (stuck off)': the module sees 'not in 4WD low' although low is engaged (ratio 2.6–2.8, diesel 5.7–8.0). No manufacturer document available to us uses P0839. Dependent diagnostics could then run wrongly in low range, so modules suspend them or use a substitute value.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 39

Possible causes

  • Switch signal or ground wire open, connector unplugged high
  • Signal wire shorted to positive medium
  • Switch or sensor open internally medium
  • Control module low

Symptoms

  • 4WD indicator flashes or stays off
  • 4WD range cannot be selected or display wrong
  • Possibly check engine lamp (depends on manufacturer)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0839

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication