OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0838

Four Wheel Drive (4WD) Switch Circuit Low

The four-wheel-drive switch tells the engine module which transfer case range is engaged. 4WD low changes the ratio of engine to road speed by about 2.7:1 on GM trucks, so GM uses 'not in 4WD low' as an enable condition for idle speed and clutch pedal checks; that is why CARB requires monitoring such inputs. P0838 means the switch signal is below its valid range – typically a signal wire shorted to ground or a switch shorted internally. Low and high refer to the signal, not to low range: with a pull-up and a switch to ground, a short to ground can look like a range permanently engaged, which GM describes for its 4WD low switch as 'ground (stuck on)'. No manufacturer document available to us uses P0838 or publishes thresholds.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 38

Possible causes

  • Signal wire chafed through to ground high
  • Switch or sensor shorted internally medium
  • Water or corrosion in the connector (leakage to ground) medium
  • Control module low

Symptoms

  • 4WD indicator flashes or stays off
  • 4WD range cannot be selected or display wrong
  • Possibly check engine lamp (depends on manufacturer)

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0838

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication