P082E
Gear Lever Y Position Sensor 1 Circuit Low
Gear lever X and Y position sensors detect a selector's position in two directions: on an H-gate shift and select direction (a LuK patent uses two sensors about 90° apart), on a shift-by-wire lever its two axes. P0820 covers the whole X-Y circuit, P0821–P0824 and P082A–P082F sensor 1, P089A–P08A3 a redundant sensor 2. GM uses P082A–P082F on its electronic range selector (2019 tables, Cadillac XT4, 2025): a Hall sensor delivers a PWM signal, measured as duty cycle. P082E is P082B for the Y axis: the duty cycle of Y sensor 1 is too low – below 17 % in 2019 or below 5 % in 2025, with 3 of 4 or 10 of 12 samples. Type B, MIL after two trips; sensor 2 takes over, and with both failed the vehicle goes to park.
Possible causes
- Signal wire shorted to ground high
- Sensor supply open medium
- Sensor in the selector assembly faulty medium
- Control module low
Symptoms
- Check engine lamp after two trips (GM)
- 'Shift to park' message or transmission warning
- Range selection restricted; with both sensors failed the vehicle goes to park
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P082E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.