OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P082C

Gear Lever X Position Sensor 1 Circuit High

Gear lever X and Y position sensors detect a selector's position in two directions: on an H-gate shift and select direction (a LuK patent uses two sensors about 90° apart), on a shift-by-wire lever its two axes. P0820 covers the whole X-Y circuit, P0821–P0824 and P082A–P082F sensor 1, P089A–P08A3 a redundant sensor 2. GM uses P082A–P082F on its electronic range selector (2019 tables, Cadillac XT4, 2025): a Hall sensor delivers a PWM signal, measured as duty cycle. P082C means the duty cycle of X sensor 1 is too high – the signal stays high, a short to positive or an open on a pulled-up input. GM sets it above 88 % with 3 of 4 samples (2019) or above 95 % with 10 of 12 samples (2025), type B with the MIL after two trips. As with P082B, sensor 2 takes over, and with both failed the vehicle goes to park.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 2C

Possible causes

  • Signal wire shorted to positive high
  • Signal or ground wire open (pulled-up input) medium
  • Sensor faulty medium
  • Control module low

Symptoms

  • Check engine lamp after two trips (GM)
  • 'Shift to park' message or transmission warning
  • Range selection restricted; with both sensors failed the vehicle goes to park

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P082C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication