OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0827

Up and Down Shift Switch Circuit Low

Many selectors read tap-up and tap-down over one shared wire with voltage steps or a resistor network; P0826–P0828 cover this shared circuit, P0815/P0816 the single directions. P0827 means the shared circuit voltage is too low – a short to ground, depending on the design an open on a pulled-up input, or a switch held closed. The only documented user is Ram's 2025 heavy-duty truck with the 6.7 Cummins and eight-speed TorqueFlite HD: a 2026 bulletin lists P0827 with P0826 and P085F and the MIL; the display shows N although P is engaged, the engine cannot be switched off and limp mode is possible. The fix was new transmission software. Saab reports the same state under P0826 (below 0.2 V for 30 s), GM under P0826.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 27

Possible causes

  • Signal wire shorted to ground high
  • Tap switch held closed or selector assembly faulty medium
  • Transmission software (Ram 2025) medium
  • Control module faulty low

Symptoms

  • Tap or manual shifting not working
  • MIL (Ram)
  • N shown although in P, engine cannot be switched off (Ram)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0827

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication