P0823
Gear Lever X Position Sensor 1 Circuit Intermittent/Erratic
Gear lever X and Y position sensors detect a selector's position in two directions: on an H-gate shift and select direction (a LuK patent uses two sensors about 90° apart), on a shift-by-wire lever its two axes. P0820 covers the whole X-Y circuit, P0821–P0824 and P082A–P082F sensor 1, P089A–P08A3 a redundant sensor 2. P0823 watches X sensor 1 for short dropouts and jumps – a signal that changes faster than the lever can move, or briefly disappears. Such checks typically count jumps within a time window; no manufacturer publishes thresholds. GM folds a disturbed X signal (a frequency error of the PWM signal) into P082A, and its patent rejects a value at once if it was faulty before and differs from its partner.
Possible causes
- Loose contact at the selector connector high
- Chafed or broken wire in the harness to the console medium
- Sensor worn (potentiometer track) or Hall sensor disturbed medium
- Interference or ground fault low
Symptoms
- Transmission warning comes and goes
- Selected range occasionally not accepted
- Occasional limp-mode reaction
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0823
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.