P0821
Gear Lever X Position Sensor 1 Circuit
Gear lever X and Y position sensors detect a selector's position in two directions: on an H-gate shift and select direction (a LuK patent uses two sensors about 90° apart), on a shift-by-wire lever its two axes. P0820 covers the whole X-Y circuit, P0821–P0824 and P082A–P082F sensor 1, P089A–P08A3 a redundant sensor 2. P0821 is the general circuit fault of X sensor 1 – an open or invalid signal – for modules that do not report low and high separately. No manufacturer document available to us uses it; GM reports the same axis in finer steps as P082A, P082B and P082C. A GM patent describes checking each sensor's x value separately: an invalid value makes that sensor unusable, and with a redundant sensor 2 the car can usually go on.
Possible causes
- X position sensor in the selector assembly faulty high
- Signal wire or connector open or corroded high
- Liquid or dirt in the center console medium
- Control module low
Symptoms
- Transmission warning in the cluster
- Ranges partly not selectable
- With both sensors failed the vehicle stays in P or N
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0821
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.