P081C
Park Input Circuit
P081C concerns the input 'park position' – the P contact of the selector or shift module, or the park pawl feedback – which controls switching off the ignition, key release, starter release and the 'not in park' warning. It is documented on the 2017–22 Jeep Compass with the nine-speed automatic: a 2022 bulletin lists P081C with the MIL on, with 'Vehicle not in Park' shown although P is engaged; the car cannot be switched off, modules stay awake and the battery drains. The cause was shift module software, fixed by reflashing. The check is a circuit or plausibility test of the P signal against the range sensor; no thresholds are published.
Possible causes
- Shift module software (Jeep Compass) high
- P contact or selector switch faulty or misadjusted medium
- Selector cable misadjusted medium
- Wire or connector medium
Symptoms
- 'Not in park' message although P is engaged
- Ignition cannot be switched off, battery drains
- Check engine lamp (Jeep)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P081C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.