P081B
Starter Disable Circuit High
The starter disable line carries the signal 'park or neutral – start allowed' from the transmission module, or its built-in range switch, to the body or engine module, which only then releases the starter. On Saab's 2010 9-5 automatic the line is open in a drive range (0 V at the body module) and closed in P or N (12 V). P081B means the start release line stays at positive, so the 'P/N' level is present in a drive range. Saab's 2012 9-3 checks it only outside P and N, with 9–18 V and not in limp mode. A short to positive could in principle allow a start in gear; the diagnosis catches it, and Saab names as the effect that the engine may not start because the release is refused.
Possible causes
- P/N line shorted to positive (chafed against a supply wire) high
- Moisture or corrosion in the connector medium
- Transmission module output stage faulty low
Symptoms
- Engine does not start or starts unreliably
- Start release in the wrong range possible (safety risk)
- No check engine lamp
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P081B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.