P0818
Driveline Disconnect Switch Input Circuit
P0818 concerns a switch input that reports whether the driveline is disconnected – on four-wheel-drive vehicles typically the neutral position of the transfer case or an axle disconnect, on hybrids a disconnect clutch between engine and transmission, as a Ford patent uses the term. It matters for OBD because in transfer case neutral the engine runs without load and wheel speed does not match the ratio, so misfire, ratio and vehicle speed monitors must know about it; CARB requires monitoring only then. The check would be a circuit or plausibility test against the speed ratio. No manufacturer document available to us uses P0818, and which of the two meanings applies cannot be proven. All-wheel drive or neutral may then be unavailable.
Possible causes
- Neutral or disconnect switch at the transfer case or axle faulty high
- Underbody wiring or connector corroded or damaged high
- Transfer case actuator does not reach its end position medium
- Control module or software low
Symptoms
- All-wheel drive or neutral cannot be selected
- 'Service 4WD' or similar warning
- Possibly check engine lamp (depends on manufacturer)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0818
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.