OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P080D

Upshift/Skip Shift Solenoid Control Circuit High

GM's skip-shift (CAGS) on manual gearboxes such as the T56 and TR6060 uses an engine-module solenoid that, at light load, blocks the way from 1st into 2nd so the driver shifts 1 to 4; the 1-4 lamp shows it (P0804). The engine module drives the solenoid with a low-side driver; P0803 is the open circuit. P080D means the control line is shorted to positive: with the low-side driver on, the line should be pulled to ground but reads high (GM: 0.5 Ω or less to the supply). The solenoid cannot be energized and the driver is protected or switched off. GM checks it only with the driver on, from 9 V (2015/16: 11–32 V) and above 250 rpm, 5 of 6 samples of 250 ms, type B with the MIL after two trips in all tables from 2015 to 2019. Without power the solenoid does not lock, so 1 to 2 stays free.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 0D

Possible causes

  • Control wire shorted to battery voltage (damaged harness) high
  • Solenoid coil with shorted turns (resistance near zero) medium
  • Substitute resistor ('eliminator') with too low a value medium
  • Engine module driver faulty low

Symptoms

  • Check engine lamp after two trips
  • 1-4 lockout not working
  • Otherwise no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P080D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication