P080A
Clutch Position Not Learned
The 'Clutch Position Sensor A' family (P0805 circuit to P0809, P080A not learned) means different parts by vehicle generation. GM used P0806–P080A until model year 2018 for the analog clutch pedal sensor of its manual cars, then the newer pedal sensor codes P08A8 ff; Saab's 2012 9-3 does the same. Ford's DPS6 dual clutch uses the family for the electric motor of clutch A. P080A means the learned clutch position is missing or implausible. On GM manual cars the factory learns the pedal position 'clutch fully pressed', and the engine module then tracks it as the clutch wears; a learned value outside 9.0–36.0 % of travel sets the code (250 ms, type A, one trip), a factory counter keeps the MIL off during assembly. Saab clears it by relearning with the scan tool. A relearn is needed after replacing the pedal sensor, master cylinder, clutch or engine module.
Possible causes
- Relearn not done after sensor, clutch or module replacement high
- Clutch badly worn or misadjusted medium
- Pedal sensor misadjusted or wrongly fitted medium
- Engine module reprogrammed or replaced medium
Symptoms
- Check engine lamp on
- Start-stop, cruise control or hill start assist disabled
- Engine may start only with the pedal at the stop
Inspection / repair
- Difficulty: easy
- DIY: shop recommended
What Pro shows you for P080A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.