P0808
Clutch Position Sensor A Circuit High
The 'Clutch Position Sensor A' family (P0805 circuit to P0809, P080A not learned) means different parts by vehicle generation. GM used P0806–P080A until model year 2018 for the analog clutch pedal sensor of its manual cars, then the newer pedal sensor codes P08A8 ff; Saab's 2012 9-3 does the same. Ford's DPS6 dual clutch uses the family for the electric motor of clutch A. P0808 means the signal is too high. GM sets it above 96 % of the 5 V reference with the same 200 of 250 samples of 12.5 ms, type A with the MIL after one trip; Saab's 2012 9-3 above 4.8 V for longer than 0.6 s, with cruise control switched off. Typical causes are an open sensor ground or a signal wire shorted to the 5 V reference or battery voltage.
Possible causes
- Sensor ground open high
- Signal shorted to 5 V or battery voltage medium
- Pedal sensor faulty medium
- Moisture or corrosion in the connector low
Symptoms
- Check engine lamp on
- Cruise control not working
- Start-stop disabled
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0808
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.