OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0807

Clutch Position Sensor A Circuit Low

The 'Clutch Position Sensor A' family (P0805 circuit to P0809, P080A not learned) means different parts by vehicle generation. GM used P0806–P080A until model year 2018 for the analog clutch pedal sensor of its manual cars, then the newer pedal sensor codes P08A8 ff; Saab's 2012 9-3 does the same. Ford's DPS6 dual clutch uses the family for the electric motor of clutch A. P0807 means the signal is too low. GM's three-wire pedal sensor on a 5 V reference has dead bands at both ends: below 4 % of the reference counts as low or open, 200 of 250 samples of 12.5 ms (about 3 s), engine not cranking, over 9 V, type A with the MIL after one trip. Saab names an open circuit or short to ground. With the clutch position unknown, cruise control, start-stop and starter release by the sensor are blocked.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 07

Possible causes

  • Signal wire open or shorted to ground high
  • 5 V reference of the sensor missing medium
  • Pedal sensor faulty internally medium
  • Connector corroded or pins loose medium

Symptoms

  • Check engine lamp on
  • Cruise control not working
  • Start-stop disabled, possibly no engine start

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0807

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication