OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0803

Upshift/Skip Shift Solenoid Control Circuit

GM's skip-shift (CAGS) on manual gearboxes such as the T56 and TR6060 uses an engine-module solenoid in the shifter housing that, at light load and low speed blocks the way from 1st into 2nd and 3rd so the driver shifts 1 to 4 – a measure for fuel economy ratings; the 1-4 lamp (P0804) shows it. P0803 means the solenoid control circuit is open. GM's tables check the low-side driver while it is off: too low a voltage or over 200 kΩ to ground, with at least 9 V and over 250 rpm, 5 of 6 samples of 250 ms (2019 LT5: 20 of 25), type B with the MIL after two trips; shorts are P080C and P080D. An open circuit leaves the solenoid unpowered, so 1 to 2 always works. 'Skip-shift eliminators' with the wrong resistance are a frequent cause.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number8 / 03

Possible causes

  • Solenoid unplugged or replaced by a skip-shift eliminator with the wrong resistance high
  • Connector at the gearbox loose or corroded high
  • Solenoid coil open medium
  • Harness damaged medium
  • Engine module driver faulty low

Symptoms

  • Check engine lamp after two trips
  • 1-4 lockout no longer works (1-2 always possible)
  • Otherwise no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0803

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication