P0802
Transmission Control System MIL Request Circuit/Open
On older vehicles with a separate transmission module and no MIL message on the CAN bus, the transmission module signals 'MIL on' over its own wire to the engine module. P0802 checks this wire for an open circuit. GM's Duramax tables of 2004 and 2005 (Allison 1000) describe it: at key-on the transmission module briefly pulls the line active like a bulb check; if the engine module sees no off-to-on transition between 0.125 and 7 s after ignition, the line is treated as open – type B, MIL after two trips. Only then is P0700 evaluated. The wire itself must be monitored because an open line would stop transmission emission faults from lighting the MIL. Newer vehicles send the request over CAN, where faults appear as U codes.
Possible causes
- MIL request wire or connector between the modules open or corroded high
- Transmission module without power or ground (fuse, relay) medium
- Module output or input faulty low
- Wrong or retrofitted transmission module without this line low
Symptoms
- Check engine lamp on
- Transmission faults no longer light the MIL
- Usually no change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0802
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.